Now as the devices are configured with the management IP address.
The command for assigning the IP address and gateway on Palo Alto is set deviceconfig system ip-address 10.0.0.2 netmask 255.255.255.0 default-gateway 10.0.0.10 ( Note: This is how to assign the IP address and gateway on Palo Alto)Ĭheck the reachability of both firewalls PaloAlto01 and PaloAlto02 from Workstation PC, Now Go to your PC and try to ping firewall from Command Prompt: Initialize PaloAlto02 with management IP address 10.0.0.2/24, please refer below snapshot. Just click on the icon on the lab screen and you will get the console access to the firewall. Now assign the IP address on Palo-Alto02 firewall from Command Line Interface.
Here is the Palo Alto default user name and password Now follow below command to initialize the firewall and assign gateway and management IP address. Task 3:Now assign the IP address on Palo-Alto01 firewall from Command Line Interface. Now assign the IP address from the management subnet, in this case it is 10.0.0.10/24, we will not assign Default gateway for this lab-practice. Note: Please disable Red marked adapter as this interface is for internet access and you may encounter issues during lab-practice. Configure below Orange marked adapter with the management address of the firewall. Task 2:Now configure network adapter on PC for taking management access. Below diagram shows the configuration on switch for this. Put interfaces Eth1/0, Eth3/1 and Eth4/0 in VLAN 50 i.e. In the basic connectivity Diagram, we will configure the interfaces on switch for management of firewall. Task 1: Here we will use Workstation to manage firewall, interface that we will use for management of firewall.
Select "EVE-COMM-EmulatedLab2.0" right mouse button -> Settingsħ. Restore the default settings successfully -> OKĦ. Lower left corner->Restore default settingsĤ. At the top left of the "VMware Workstation Pro" interface->Edit->Virtual Network Compilerģ. The following are the detailed steps (simple and rude) of this problem, of course, it also needs specific analysis of the specific situation!Ģ.
It is not difficult to solve this method if you reinstall the system in the future, install EVE first, and then add the virtual network card, No IP address on interface pnet0 will not happen. The installation of EVE went smoothly before, but this time it got stuck (stuck at No IP address on interface pnet0). Then I directly come up with a simple and crude method I think I used two default virtual network cards when I installed EVE before, so I just try to restore the default settings today. I checked many methods on the Internet and it didn’t work. When I opened it, I found that there was no address and this picture appeared I didn’t post it for a long time. Some time ago, I reinstalled the system on my computer, and then did a multicast bridge experiment between GNS3 and eNSP.